Detailed explanation of the operation page of the vibrating knife cutting machine

1.Basic knowledge of start-up operation and understanding of fuselage routines.
1.Turn on the power button
2.Release the emergency stop button to the right (Note: After pressing the emergency stop button every time, you need to release it to the right before starting to use it) 
3.Return to the original point (when the device does not return to the original position, press back to the original point, and the device will automatically return to the original point)
2.Detailed introduction of each function of the work page (the detailed picture of the work page is compared by number)
1.:Boot the main page
2.Turn right on the W axis
3.Move in the Y+ direction
4.Turn left on the W axis
5.Move in the direction of X+
6.Set the operating value (unit: mm)
7.Move in the X-direction
8.Z-axis upward movement
9.Move in the Y-direction
10.Z-axis fall
11.Turn right with the punch
12.Turn the punch to the left
13.Suction switch
14.Fast/slow switching
15.Start cutting
16.Determine the working point
17.Look for material borders
18.Go to the workbench point
19.Cancel the cut
20.Run to X+ maximum stroke
21.Run to Y+ maximum stroke
22.Run to X-Max Stroke
23.Run to Y-max stroke
24.Pause cutting/Resume cutting